AVANT 744i - Attachment Manuals and Coupling Procedures

Avant 755i 760i Working with attachments
89
.
Manuals of attachments
DANGER
Attachments can create significant risks that are not
covered by this Operator's manual of the loader.
Make sure you have all attachments manual ava
ilable.
Wrong use of an attachment can cause serious injuries or
death.
Each attachment is accompanied by its own respective
Operator’s Manual. The manual will show important
information related to safety, and how to attach, use, and
maintain each attachment correctly.
WARNING
Risk of injuries from incompatible attachments -
Make sure attachment is intended
to be used with this loader model.
Wrong type of attachment, poor locking of the
attachment, or wrong technical characteristics of coupling bracke
ts can cause hazards
that are not taken into account by design of the loader or the individual attachment. Never
use other than original Avant attachments and brackets.
Third party manufacturers of attachment must carry out detailed engineering
and risk
as
sessment to ensure safety, performance, and reliability of the combination of the loader
and the attachment. Consult your Avant dealer if you are unsure about the compatibility
of the equipment with your Avant loader.
Compatibility of attachments
Use only Avant attachments that have been designed for your loader model. Any attachment that is fitted to the
loader must be designed to be used specifically with Avant 755 / 760, and this must be stated in the operator's
manual of the attachment. The manufacturer of the attachment is responsible for evaluating the risks related to
coupling the attachment and using it with this loader model. Do not any attachment if the manufacturer of the
attachment has not declared its compatibility with this loader model in writing.
. ..
Check max. allowed hydraulic oil flow for the attachment. Adjust the speed of the
hydraulic pump so that the output flow is suitable for the work and the attachment. See
page 38.
Notice that some third party attachments may have hydraulic oil that is not intended to
mixed with the oil in the hydraulic oil of the loader. Flushing of the hydraulic oil circuit of
the attachment may be necessary before coupling to the loader. I
ncompatible oils can
cause wearing of hydraulic pumps and motors.