Controls and options of the Loader Avant 755i 760i
74
Defrosting/De-misting:
Turn heater fan to position 4 (high speed)
Set temperature to warmest possible
Switch on A/C (if fitted). The air conditioning will
dry air
Direct front vents towards the windows. Close
other vents
Keep air recirculation hatch closed. Using the air
recirculation will increase moisture in the cabin
CAUTION
Risk of collision -
Never drive
the loader when the visibility is
poor.
Do not drive unless basic
visibility in all directions is
achieved. Allow the loader to warm
up properly.
Air conditioning (Option for cab DLX)
Cab DLX can be equipped, as an option, with air
conditioning. A/C switch is located on the panel up to
the right. The A/C condenser is mounted at the
factory either on the roof of the loader, or when lower
overall height is wanted, to the rear of the cab. The
condenser should be kept clean and clear of debris.
During winter, switch on the air conditioning for a few
minutes weekly in order to lubricate AC circuit and to
maintain the compressor in good condition.
To keep the A/C functioning efficiently, the system
should be serviced after every 2 years. Service of
A/C systems is only allowed for authorized and
trained service personnel.
The A/C will work only while the
fan is switched on.
To Next Page
Loading...
