You can enter three three-digit external line codes in the audit menu. This codes are checked if
the telephone is locked with a local PIN. Depending on this check a call is either executed or
rejected.
Note:
If the PIN is set in the system, these settings determine the length and evaluate the selection
code for external calls.
1. Open the audit menu.
2. Select External line codes.
3. Press the OK button.
4. Select one of the following:
• Code 1 lock
• Code 2 lock
• Code 3 lock
5. Enter one to three digits of the external line code.
6. Press the Done softkey.
Setting up a PIN for outgoing external calls
Making an external call, the subscriber can dial an additional PIN or project number, which is
transferred to the central call charge data recording.
1. Open the audit menu.
2. Select External line codes.
3. Press the OK button.
4. Select Code 4 PIN check.
5. Enter a maximum 5 digit ELC (= external line code) for outgoing external calls and
then the PIN or project number. This ELC is set up for general or individual PIN
checks in the telephone system. To enable call charge data recording to recognize
the PIN, the ELC for dialling with PIN must be different from the ELC for dialling
without PIN. This must be set up in the telephone system accordingly.
6. Select PIN check duration.
Setting up a PIN for outgoing external calls
1408/1416 Telephones IAM Guide January 2010 35
To Next Page
Loading...
