Suppressing specific status information
Usually the status information shows activated call diversions in the display. Some of these
status messages can be suppressed partly or totally.
1. Open the audit menu.
2. Select Show telephone status.
3. Press the OK button.
4. Select one of the following:
• Call diversion if you want to suppress the call number of the call diversion
destination in the status message.
• Intern after time if you want to suppress the complete status message in
case a call diversion “internal after time” is activated.
• Ex.aft.time if you want to suppress the complete status message in case
a call diversion “external after time” is activated.
5. Press the Done softkey.
Setting redial list
The redial list can contain up to 30 entries. Up to ten of these are reserved for the most recently
dialed numbers. The remaining entries are generated by callback request. Each callback
request that you initiate is its own entry in the redial list.
The number of entries for the most recently dialed numbers can be decreased.
1. Open the audit menu.
2. Select Set redial.
3. Press the OK button.
4. Select Number.
The number of redial list entries reserved for the most recent dialed numbers is
shown.
5. Enter a value between 1 and 10.
6. Press the Done softkey.
Telephone installation
40 1408/1416 Telephones IAM Guide January 2010
To Next Page
Loading...
