Avaya 3500 - Quick Start

Important:
For security reasons, it is recommended that you configure the passwords to values other than
the factory defaults.
For more information about configuring passwords, see:
• Configuring Security on Avaya Ethernet Routing Switch 3500 Series, NN47203-504
Quick Start
You can use the install command in Avaya Command Line Interface (ACLI) or the Quick Start
menu in Enterprise Device Manager (EDM) to configure the following:
• quick start VLAN
• in-band IP address and subnet mask
• default gateway
• management subnet mask, management IP address and management default gateway
• read-only and read-write community strings
• IPv6 in-band address and IPv6 default gateway
• management IPV6 address and management IPV6 default gateway
Enterprise Device Manager
Enterprise Device Manager (EDM) is an embedded graphical user interface (GUI) that you can use
to manage and monitor the platform through a standard web browser. EDM is embedded in the
switch software, and the switch operates as a web server, so you do not require additional client
software. For more information about EDM, Using ACLI and EDM on Avaya Ethernet Routing
Switch 3500 Series, NN47203-102.
Enterprise Device Manager access
To access EDM, open http://<deviceip>/login.html or https://<deviceip>/
login.html from either Microsoft Internet Explorer (minimum version 8.x), or Mozilla Firefox
(minimum version 3.x).
Important:
You must enable the web server from ACLI to enable HTTP access to EDM. If you want HTTP
access to the device, you must also disable the web server secure-only option. The web server
Fundamentals
September 2016 Quick Start Configuration 10
Comments on this document? infodev@avaya.com