Variable Value
{count <1–9999>} | continuous Sets the number of ICMP packets to be sent. The
continuous mode sets the ping running until the user
interrupts it by entering Ctrl-C.
{timeout |-t} <1–120> Sets the timeout using either the timeout or -t
parameter, followed by the number of seconds the
switch must wait before timing out.
interval<1–60> Specifies the number of seconds between
transmitted packets.
debug Provides additional output information such as ICMP
sequence number and trip time.
source<A.B.C.D> Specifies the source IP address of the packet. Must
be a configured address on the switch.
ttl<0–255> Specifies the maximum hop limit for the packet.
Range of 0 to 255.
Variable definitions
The following table describes the parameters for the show boot command.
Variable
Value
diag Displays information for the diagnostic load only.
image Displays information for the image load only.
Displaying the agent and diagnostic software load
Display the currently loaded and operational software status for agent and diagnostic loads, either
individually or combined, for a switch or stack.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show boot [diag] [image]
Example
The following figure provides a sample output of the show boot command.
Switch>show boot
Unit Agent Image Active Image Diag Image Active Diag
----- ----------- ------------ ---------- -----------
1 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
2 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
3 5.2.0.037 5.2.0.037 1.0.0.11 1.0.0.11
Verification
September 2016 Quick Start Configuration 47
Comments on this document? infodev@avaya.com
To Next Page
Loading...
