Creating a VLAN using ACLI
Use this procedure to create port-based or IPv6 protocol-based VLANs.
Important:
This procedure fails if the VLAN already exists.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
vlan create {<1–4094> | <vid_list>} [name <WORD>] [ type { port |
protocol-ipv6Ether2 | voice-vlan}] | [voice-vlan] [msti <1–7> |
cist]
Example
vlan create 2-10,80 type port
vlan create 15 type voice-vlan
Variable definitions
The following table describes the parameters for the vlan create command.
Variable
Value
<1–4094> | <vid_list> Enter the ID of the VLAN you want to create or enter
as a list or range of VLAN IDs to create multiple
VLANs simultaneously. A VLAN ID can range from 1
to 4094..
name <WORD> Enter the new name you want for the VLAN.
type Enter the type of VLAN. Values include:
• port — port-based VLAN
• protocol-ipv6Ether2 — IPv6 protocol-based VLAN
• voice-vlan — voice VLAN
msti <1–7> | cist This parameter is available only in MSTP mode. It
associates the VLAN with either an MSTI instance or
the CIST.
Connecting to the switch
September 2016 Quick Start Configuration 36
Comments on this document? infodev@avaya.com
To Next Page
Loading...
