Chapter 3: Fundamentals
Quick Start Configuration for Avaya Ethernet Routing Switch 3500 Series, NN47203-301 includes
the minimum, but essential, configuration steps to:
• Provide a default, starting point configuration
• Establish a management interface
• Establish basic security on the node
The shipment includes the following:
• An installation kit
• A foldout poster, Quick Install Guide for Avaya Ethernet Routing Switch 3500 Series,
NN47203-300
For more information about hardware specifications and installation procedures, see Installing
Avaya Ethernet Routing Switch 3500 Series, NN47203–304.
For more information about how to configure security, see Configuring Security on Avaya Ethernet
Routing Switch 3500 Series, NN47203-504.
To download and print selected technical publications and release notes directly from the Internet,
go to
http://support.avaya.com.
System connection
Use the console cable to connect the terminal to the switch console port. The console cable and
connector must match the console port on the switch (DB-9 or RJ-45, depending on your model).
The following are the default communication protocol settings for the console port:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• No flow control
• VT100 or VT100/ANSI Terminal Protocol
September 2016 Quick Start Configuration 8
Comments on this document? infodev@avaya.com
To Next Page
Loading...
