Avaya 3500 - Displaying the Current Banner

enable
configure terminal
2. At the command prompt, enter the following command:
[no] banner [custom | static | disabled | <1–19> LINE ]
Variable definitions
The following table describes the parameters for the banner command.
Variable Value
static Displays the default agent-banner
custom Displays the custom agent-banner
disabled Skips the agent-banner display
<1–19> LINE Fills the Nth line of the custom banner (1<N<19) with
the text specified in LINE
no Clears all lines of a previously stored custom banner
Displaying the current banner
Display the current banner.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show banner [custom | static]
Variable definitions
The following table describes the parameters for the show banner command.
Variable
Value
static Displays default banner
custom Displays custom banner
(if empty) Displays static, custom or disabled status if
parameter is not entered
Customizing the opening banner
September 2016 Quick Start Configuration 27
Comments on this document? infodev@avaya.com