Displaying IP configuration
This procedure is used to display the IP configuration, specifically BootP mode, switch or stack or
unit address, subnet mask, and gateway address. These parameters are displayed for what is
configured, what is in use, and the last BootP.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
show ip [bootp][default-gateway [address [switch | stack | unit <1–
8>]][dns]
If you do not enter any parameters, the show ip command displays all IP-related
configuration information.
Example
The following figure displays a sample output of the show ip command.
Switch>show ip
Bootp/DHCP Mode: BootP Or Default IP
Configured In Use Last BootP/DHCP
------------- ------------- ---------------
Stack IP Address: 172.16.120.10 0.0.0.0
Switch IP Address: 172.16.120.12 172.16.120.12 0.0.0.0
Switch Subnet Mask: 255.255.255.0 255.255.255.0 0.0.0.0
Default Gateway: 172.16.120.1 172.16.120.1 0.0.0.0
switch>
Variable definitions
The following table describes the parameters for the show ip command.
Variable
Value
bootp mode Displays BootP-related IP information.
default-gateway Displays the IP address of the default gateway.
address Displays the current IP address.
switch | stack | unit <1–8> Specifies the current IP address of the switch or
stack or specified unit.
dns Displays the DNS configuration.
Displaying IP configuration
September 2016 Quick Start Configuration 45
Comments on this document? infodev@avaya.com
To Next Page
Loading...
