Clearing the IP address
Use this procedure to clear the existing IP address and subnet mask for the switch or stack or
another unit of a stack.
Important:
When you change the IP address or subnet mask, you can lose connection to Telnet and the
Web. You also disable any new Telnet connection, and you must connect to the serial Console
port to configure a new IP address.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
no ip address [switch|stack|unit<1–8>]
Configuring the IP address to the default value
The default value for the switch is 192.168.1.1 for Standalone Mode or 192.168.1.2 for Stacking
Mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
default ip address
Displaying IP address information
Use this procedure to display IP configurations, switch address, subnet mask, and gateway address.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
Configuring the switch using ACLI
September 2016 Quick Start Configuration 42
Comments on this document? infodev@avaya.com
To Next Page
Loading...
