If you ran the install script to set up the configuration information, the read-only
community name is already configured.
4. Configure the read-write community name:
snmp-server community rw
Note:
Enter the community string twice.
If you ran the install script to set up the configuration information, the read-write
community name is already configured.
5. Configure the system name:
snmp-server name <text>
6. Configure the system contact:
snmp-server contact <text>
7. Configure the location:
snmp-server location <text>
8. Configure the SNMP host to add a trap receiver to the trap-receiver table:
snmp-server host <host-ip> <community-string>
Variable definitions
Use the definitions in the following table to use the snmp-server name command.
Table 1: snmp-server name command
Variable Definition
<text> Specify the SNMP system name value. Enter an
alphanumeric string of up to 255 characters.
Note:
On the console, the SNMP server name is
truncated. On the web interface, the full SNMP
server name appears.
Use the definitions in the following table to use the snmp-server contact command.
Table 2: snmp-server contact command
Variable Definition
<text> Specify the SNMP system contact value. Enter an
ASCII string of up to 255 characters.
Connecting to the switch
September 2016 Quick Start Configuration 38
Comments on this document? infodev@avaya.com
To Next Page
Loading...
