Use the definitions in the following table to use the snmp-server location command.
Table 3: snmp-server location command
Variable Definition
<text> Specify the SNMP system location value. Enter an
alphanumeric string of up to 255 characters.
Use the definitions in the following table to use the snmp-server host command.
Table 4: snmp-server host command
Variable Definition
<host-ip> Specify an IPv4 or IPv6 address for a host intended
to be the trap destination.
<community-string> If you are using the proprietary method for SNMP,
enter a community string that works as a password
and permits access to the SNMP protocol.
Configuring system identification
September 2016 Quick Start Configuration 39
Comments on this document? infodev@avaya.com
To Next Page
Loading...
