Figure 29: Cross-connecting a UILC port to the office wiring
Connecting the terminating resistor to the SILC DSL
Plug the end of the SILC DSL to the RJ-45 jack on the terminating resistor (A0378866)
resistor.
Connecting the ISDN BRI terminals
ISDN BRI terminals are connected to DSLs using modular cables not longer than 10 m (33 ft)
with RJ-45 type plugs on each end. One end of the cable is plugged into the terminal, and the
other end is plugged into the telephone outlet.
Configuring ISDN BRI hardware
72 ISDN Basic Rate Interface Installation and Commissioning March 2011
To Next Page
Loading...
