Avaya CS 1000 Series - Chapter 9: Generating Traffic Reports; Contents; Introduction

Chapter 9: Generating traffic reports
Contents
This section contains information on the following topics:
Introduction on page 95
Introduction
This chapter describes how to generate traffic reports to verify that the traffic generated during
voice and data transmission testing is stored by the system and can be printed on demand.
To verify traffic generated during acceptance testing, use the following command:
INVS (options)*
The asterisk (*) denotes that the ENTER key must be pressed after the desired option numbers
are entered.
Reports are generated using one or more of the following option numbers.
Option Meaning
1 Network traffic report
11 ISDN BRI MISP and/or BRSC traffic report
12 ISDN BRI MISP and/or BRSC D-channel management messages report
13 ISDN BRI MISP and/or BRSC messages report
14 Trunk DSL system traffic report
15 MPH traffic report
For example, to verify ISDN BRI traffic generated during acceptance testing, select the network
traffic report and the MISP traffic report as follows:
INVS 1 11
The system printer should print these two reports. Check the reports to make sure the traffic
generated during the test is reflected in the reports.
ISDN Basic Rate Interface Installation and Commissioning March 2011 95