Page 12 - Site Surveys
Page 12 DECT - Installation Manual
Using the Site Survey Kit 38HBKD0001SAH – Issue 14 (27th October 2003)
Subscribing to the Survey Base Station
Up to eight handsets can be subscribed to the Survey Base Station. All
these handset can display the RSSI signal quality simultaneously but only
one can receive the audio input at any time. Normally only one handset is
subscribed to the Survey Base Station.
1. Connect the Survey Base Station connected to it's power supply and
switch on.
2. Turn the handset on and use the following step to assign it a number
between 1 and 8. Dial *99972*x where x is the number between 1 and
8 (each handset must have a unique number). Then press ✓.
3. Press MENU and the > key until LOGIN appears and then press ✓.
SELECT LOGIN appears.
4. Press the > key until required SYSTEM number (1-4) appears then
press ✓.
5. Press > until SUBSCRIPTION REMOVE appears, then press ✓.
6. Enter the password (default 0000) and press ✓ to display
SUBSCRIPTION REMOVE? Press ✓ to display any previously
entered System ID (appears below SYSTEM X where X = 1 to 4).
Remove previously subscribed ID by pressing ✓.
7. You are returned to SUBSCRIPTION CREATE. Press ✓ to begin
subscription.
8. The handset is now searching for a system to which it can subscribe.
Press and hold the subscribe button on the Survey Base Station for
three seconds. The Survey Base Station will then stay in subscribe
mode for one minute.
9. Use the < and > buttons to display the ID numbers of available DECT
systems found by the handset. Look for the ID number of the Survey
Base Station (printed on the back of the Survey Base Station) and
then press ✓.
10. Use the < and > to select which system you want the Survey Base
Station assigned as and then, at the AC: prompt, enter 12345678 and
press ✓.
11. SUBSCRIPTION WAIT appears. When successfully subscribed, the
handset bleeps. Should SUBSCRIPTION FAILED appear, repeat from
step 5 removing any previously subscribed ID for the SYSTEM
number you are attempting to subscribe too.