Page 66 - Using SIO
Page 66 DECT - Installation Manual
SIO Commands 38HBKD0001SAH – Issue 14 (27th October 2003)
Shift F7 - USRMOVE
Allows the handset programming set for one DAB card/channel to be
moved to another DAB card/channel. Note: You can only move to a
channel that is not already configured.
Shift F8 - IWUREAD
Shows the hex value of settings for a selected DAB Card.
Shift F9 - IWUCONFIG
Allows the setup of hex values for a selected DAB card. * indicates a
default value.
– Ringing Frequency Detection:
01 = 13-60Hz, 02 = 20-60Hz*, 03 = 20-30Hz.
– Recall Mode:
Bit no = channel no with loop break = 1 and earth recall = 0 (see Note
1 below), e.g. FF = All loop break, 00 = All earth recall.
– Recall Timing: Loop Break
11 = 100ms*, 12 = 290ms, 13 = 630ms
– Recall Timing: Earth Pulse
01 = 400ms*, 02 = 2.5s.
– Dial Mode:
Bit no. = channel no with DTMF = 1 and pulse = 0 (see note 1 below),
e.g. FF = All DTMF, 00 = All pulse.
– DTMF Timing:
01 = 80ms, 02 = 90ms*, 03 = 100ms, 04 = 150ms (PCS7+), 05 =
200ms (PCS7+), 06 = 250ms (PCS7+), 07 = 2500ms (PCS7+).
– Pulse Timing:
01 = 40ms/60ms, 02 = 34ms/66ms.
– Dial Tone Detect Maximum Pause Time:
01 = 3s*, 02 = 4s, 03 = 6s, 04 = 8s, 05 = 1s (PCS 7+).
– Dial Tone Detect Filter:
00 = 390-460Hz, 01 = 350-500Hz, 02 = 310-540Hz*, 03 = 270-630Hz.
– Suppression:
01 = On*, 03 = Off (+10dB).
Note 1: Some settings are per channel on the DAB. Each channels is set
as a binary bit (0 or 1) in the sequence channel 1 to channel 8. The binary
sequence xxxxxxxx (ie. Channel 1 to channel 8, 0 or 1 for each channel) is
then converted to a hex value.
Shift F10 - SUBSCRIBE
Allows handset subscription to be allowed or barred . Enter 1 for allowed,
0 for barred.
Shift F11 - READ SOLO
Used to read all the users on a master or solo DCU. Warning: This
command can cause the loss of any current calls.
To Next Page
Loading...
