Hardware Installation
3-46 Issue 6 September 2001
NOTE:
If the IPEI that is displayed electronically and the IPEI from the back of the
WT (with battery removed) do not match, administer the electronically
displayed version on the WT station form.
4. Enter the IPEI into the Station form. To access the form, enter the add
station or change station command.
5. Reseat the battery. The WT should display icons and be ready for use.
NOTE:
Instructions for checking and downloading WT firmware are included in the
next chapter.
To Next Page
Loading...
Need help?
General
