Avaya


Definity - 4 CVLAN and DLG System Administration

Procedure: WT Firmware Download and Connection
Issue 6 September 2001
4-3
Figure 4-1. Status of Wireless Terminal Firmware Upgrade Form
2. Record the firmware version for the WT (if present).
3. For the 9601 WT:
a. Ensure that the WT is powered up. Then determine the WT firmware
version by pressing .
b. Press .
c. Press the Info soft key (middle up arrow).
d. Press .
For the 9630 Series WT:
a. Press .
b. Press four times.
c. Press the More soft key (first up arrow).
d. Press .
4. Compare the firmware reported in the WT with the firmware stored in either
the mass storage on the switch or the RC. If the firmware in mass storage
or the RC is older than or the same as the firmware in the WT, the
procedure is completed. If the firmware in mass storage or the RC is newer
than the firmware in the WT, a firmware download is required; therefore,
proceed to the next section.
STATUS OF WIRELESS TERMINAL FIRMWARE UPGRADE
Server Server WT Firmware Firmware WT WT State of
Page 1status wt-upgrade
Location Enabled? in Server Version Connected? IPEI Operation
01C18 Yes 9601 0.5.7 No 000000000 Idle
01C10 Yes 9601 8.4.6 No 0011179eb Idle
Menu
Next
Prev
Menu
Next
Next