Avaya EC500 - Enabling EC500 from Your Office Telephone Network Using the Feature Access Code

Enabling/disabling EC500 and maintaining security
30 Issue 4 May 2003
When enabled via an administered feature status button on the office telephone,
no feature access code is required.
Enabling EC500 from your office telephone
network using the feature access code
NOTE:
You should have the EC500 "enable" feature access code recorded on your
pocket reference card.
Perform this procedure from any touch-tone phone.
1. Dial the EC500 "enable" feature access code.
You hear a dial tone.
2. If you are performing this procedure from an extension other than your
office phone, enter your office phone’s extension number.
If you are performing this procedure from your office phone, or from your
EC500 cell phone which sends office caller ID, skip this step and go to Step
3.
3. Press # on your telephone keypad.
4. Enter your station security code.
5. Press # on your telephone keypad.
You hear a confirmation tone indicating EC500 is enabled.
6. Hang up to end the call.
Table 1. Enabling EC500 via an administered feature status button
EC500 state Timer status Push feature button Indicators
Disabled
(lamp is off)
Not administered Once Lamp glows green
Message EC500
Enabled displays
for two seconds
Disabled
(lamp is off)
Administered Once Lamp glows green
Message EC500
Enabled displays
for two seconds
Timer active
(lamp in
inverted
wink mode)
Administered Twice Lamp glows green
Message EC500
Enabled displays
for two seconds