Disabling EC500
Issue 4 May 2003
33
Disabling EC500 from your office
telephone network using the feature access code
NOTE:
You should have the EC500 "disable" feature access code recorded on your
pocket reference card.
1. Dial the EC500 "disable" feature access code.
You hear a dial tone.
2. If you are performing this procedure from an extension other than your
office phone, enter your office phone’s extension number.
If you are performing this procedure from your office phone, or from your
EC500 cell phone which sends office caller ID, skip this step and go to Step
3.
3. Press # on your telephone keypad.
4. Enter your station security code.
5. Press # on your telephone keypad.
You hear a confirmation tone indicating EC500 is disabled.
6. Hang up to end the call.
NOTE:
If you do not receive a confirmation tone, hang up, verify the codes entered
and repeat this procedure from Step 1. If you still do not receive a
confirmation tone, contact your system administrator for assistance.
If you are administered to send office caller ID, it will not be affected by the enable
or disable procedures. Only the receipt of calls at the cell phone is affected.
Disabling EC500 remotely
NOTE:
You should have the EC500 "disable" feature access code and EC500
access number recorded on your pocket reference card.
Perform this procedure from any touch-tone phone.
1. Dial the EC500 access number.
You hear a dial tone.
2. Enter the EC500 "disable" feature access code.
You hear a dial tone.
3. Enter your office phone’s extension number.
4. Press # on your telephone keypad.
To Next Page
Loading...
