Avaya J100 Series - Page 244

Parameter name Default
value
Description
PHY2PRIO 0 Specifies the layer 2 priority value
to be used for frames received on
the secondary Ethernet interface
when VLAN separation is enabled.
The parameter is not supported
when VLANSEPMODE is 1.
Valid values are 0 through 7.
PHY2STAT 1 Specifies the speed and duplex
settings for the secondary (PC)
Ethernet interface.
Value Operation:
• 0: disabled
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported
by hardware, otherwise auto-
negotiated
PHY2TAGS 0 Determines whether or not VLAN
tags are stripped on Ethernet
frames going out of the Computer
(PC) port.
Value Operation:
• 0: Strip tags. VLAN tags are
stripped from Ethernet frames
leaving the computer (PC) port of
the phone.
• 1: Does not strip tags. VLAN tags
are not stripped from Ethernet
frames leaving the Computer
(PC) port of the phone.
Note:
This parameter is configured
through the settings file.
PHY2VLAN 0 Specifies the value of the 802.1Q
VLAN ID that is used to identify
network traffic going into and
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 244
Comments on this document? infodev@avaya.com