Avaya J100 Series - Page 255

Parameter name Default
value
Description
RTCPMON Null Specifies the IP or DNS address for
the RTCP monitor.
You can set this parameter only if
the environment is not an Avaya
environment. The values can range
from 0 through 255 characters.
RTCPMONPERIOD 5 Specifies the interval, in seconds,
for sending out RTCP monitoring
reports. Valid values are from 5 to
30 seconds.
RTCPMONPORT 5005 Specifies the RTCP monitor port
number.
You can set this parameter only if
the environment is not an Avaya
environment. The values can range
from 0 through 65535. Default is
5005.
RTP_PORT_LOW Specifies the lower limit of the UDP
port range to be used by RTP or
RTCP and SRTP or SRTCP
connections.
The values can range from 1024
through 65503.
RTP_PORT_RANGE Specifies the range or number of
UDP ports available for RTP or
RTCP and SRTP or SRTCP
connections
This value is added to
RTP_PORT_LOW to determine the
upper limit of the UDP port range.
The values can range from 32
through 64511.
S
SCEPPASSWORD $SERIALN
O
Specifies the password to be
included in the change password
attribute of an SCEP certificate
request.
Values can contain 0 to 32 ASCII
characters (50 ASCII characters.
If the value contains $SERIALNO, it
is replaced by the phone's serial
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 255
Comments on this document? infodev@avaya.com