Avaya J100 Series - Page 257

Parameter name Default
value
Description
Note:
Only Avaya J169/J179 IP
Phone supports this feature.
SCREENSAVERON 240 (4
hours)
Specifies the number of minutes of
idle time after which the screen
saver is displayed.
If an image file is downloaded
based on the LOGOS and
CURRENT_LOGO parameter, it is
used as the screen saver.
Otherwise, the built-in Avaya one-
X(TM) screen saver is used.
Valid values are 0 through 999. The
default value is 240 (4 hours).
A value of 0 means that the screen
saver will not be displayed
automatically when the phone is
idle.
SDPCAPNEG 1 Specifies if SDP capability
negotiation is enabled.
Value Operation:
• 0: SDP capability negotiation is
disabled.
• 1: SDP capability negotiation is
enabled.
SEND_DTMF_TYPE 2 Specifies if DTMF tones are sent in-
band as regular audio, or out-of-
band using RFC 2833 procedures.
Value Operation:
• 1: In-band
• 2: Out-of-band
SERVER_CERT_RECHECK_HOURS 24 Specifies the number of hours after
which certificate expiration and
OCSP will be used, if OCSP is
enabled, to recheck the revocation
and expiration status of the
certificates that were used to
establish a TLS connection. Valid
values are from 0 to 32767.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 257
Comments on this document? infodev@avaya.com