Avaya J100 Series - Page 258

Parameter name Default
value
Description
Value operation:
• 0: Periodic checking is disabled.
SHOW_LAST_EXTENSION 0 Specifies whether to display last
extension after logout.
Value Operation:
• 0: To hide last extension after
logout.
• 1: To display the last extension
after logout.
SIG 0 Specifies the type of software to be
used by the phone by controlling
which upgrade file is requested
after a power-up or a reset.
Value Operation:
0: Download the upgrade file for the
same signaling protocol that is
supported by the current software
(default)
2: Download J100Supgrade.txt
SIG_PORT_LOW Specifies the minimum port value
for SIP signaling. (1024 -65503).
SIG_PORT_RANGE Specifies the range or number of
SIP signaling ports. This value is
added to SIG_PORT_LOW to
determine the upper limit of the SIP
signaling port range (32-64511).
SIGNALING_ADDR_MODE 4 Specifies the SIP controller IP
address from
SIP_CONTROLLER_LIST_2. This
parameter is used by SIP signaling
on a dual mode phone.
Value operation:
• 4: IPv4
• 6: IPv6
SIMULTANEOUS_REGISTRATIONS 3 Specifies the number of Session
Managers with which the phone
simultaneously register.
Valid values are 1, 2 or 3. The
default value is 3.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 258
Comments on this document? infodev@avaya.com