Parameter name Default
value
Description
Note:
This parameter is set to 1 in IP
Office environment.
SIP_CONTROLLER_LIST Null Specifies a list of SIP controller
designators, separated by commas
without any spaces. Controller
designator has the following format:
host[:port]
[;transport=xxx] where
• host is an proxy address in
dotted-decimal or DNS name
format. In third-party call control
setup, only DNS format is
supported.
• [:port] is an optional port
number.
• [;transport=xxx] is an
optional transport type where xxx
can be TLS, TCP, or UDP.
For example,
SIP_CONTROLLER_LIST="10.13
8.251.56:5060;transport=tc
p"
SIP_CONTROLLER_LIST_2
Null This parameter replaces
SIP_CONTROLLER_LIST for dual
mode phones. It contains the list of
SIP Proxy or Registrar servers
separated by comma when the SIP
device is configured for the dual-
stack operation.
Valid values are 0 to 255 characters
in the dotted decimal or colon-hex
format.
The SIP Proxy list has the following
format: host[:port]
[;transport=xxx] where
• host is IP addresses in dotted-
decimal format or hex format.
• [:port] is the port number. The
default values are 5060 for TCP
and 5061 for TLS.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 259
Comments on this document? infodev@avaya.com
To Next Page
Loading...
