Parameter name Default
value
Description
Note:
If default port is not used, both
the SLA Mon agent and the
server must be configured with
the same port. This parameter
impacts the phone's SLA Mon
agent configuration. A
corresponding configuration
must also be made on the SLA
Mon server agentcom-
slamon.conf file.
SLMSRVR Specifies the IP address and the
port number of the SLA Mon server
in the aaa.bbb.ccc.ddd:n format.
Set the IP address of the SLA Mon
server in the aaa.bbb.ccc.ddd
format to restrict the registration of
agents only to that server.
Specifying a port number is
optional. If you do not specify a port
number, the system takes 50011 as
the default port. If the value of the
port number is 0, than any port
number is acceptable.
The IP address must be in the
dotted decimal format, optionally
followed by a colon and an integer
port number from 0 to 65535.
To use a non-default port, set the
value in the aaa.bbb.ccc.ddd:n
format, where aaa.bbb.ccc.ddd is
the IP addressof the SLA Mon
server.
Note:
If default port is not used, both
the SLA Mon agent and server
must be configured with the
same port. SLMSRVR impacts
the phone's SLA Mon agent
configuration. A corresponding
configuration must also be
made on the SLA Mon server
agentcom-slamon.conf file
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 262
Comments on this document? infodev@avaya.com
To Next Page
Loading...
