Avaya J100 Series - Page 261

Parameter name Default
value
Description
Valid values are 0 through 60. The
default value is 5.
A value of 0 means that the Skills
screen in not removed
automatically when the agent logs
in.
SLMCAP 0 Specifies if the SLA Monitor agent
is enabled for packet capture.
Value Operation:
• 0: Disabled (default)
• 1: Enabled and payloads are
removed from RTP packets
• 2: Enabled and payloads are
included in RTP packets
• 3: Controlled from admin menu -
Allows you to enable or disable of
RTP packets capture using local
admin procedures.
SLMCTRL 0 Specifies whether the SLA Monitor
agent is enabled for phone control.
Value Operation:
• 0: Disabled
• 1: Enabled
• 2: Controlled from admin menu.
SLMPERF 0 Specifies whether the SLA Monitor
agent is enabled for phone
performance monitoring.
Value Operation:
• 0: Disabled
• 1: Enabled
SLMPORT 50011 Specifies the UDP port that will be
opened by the SLA Monitor agent
to receive discovery and test
request messages.
Valid values are 6000 through
65535. The default value is 50011.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 261
Comments on this document? infodev@avaya.com