At the customer site
03-300528 Issue 6 May 2009 45
5. Ensure that all cables (connected to the G700 and media modules) are adequately marked
for later reinstallation in the same locations.
6. Shutdown the S8300 Server, if any:
Click Shutdown Server under Server on the Server (Maintenance) Web page. Or, press
and hold down the Shutdown button (on the faceplate of the S8300) until the OK to Remove
LED starts blinking. In either case, when the OK to Remove LED is on steady, you can
safely power down the system.
7. Power down the G700 (unplug power cord).
8. Remove all cables. Remove the old G700 from the rack. Mount the new G700 in the rack.
9. Transfer the media modules and the S8300, if any, from the old G700 to the new G700,
maintaining the original slot locations.
10. Reconnect cables in the same locations as on the old G700.
11. Power up the G700 (plug in power cord).
12. Provision the new G700 (MGP, P333T Stack Processor, IP Routes):
a. Connect a serial cable from your laptop’s serial port to the Console port on the G700
b. Using a serial-communications application such as Hyperterm, access the P333T Stack
Processor and log in.
Note: The following steps, c–m, can alternatively be completed using the Gateway
Installation Wizard. To use the wizard, the GIW application must be installed on
your laptop.
c. If necessary, start the Hyperterm session and log in.
d. Provision the IP address of the P333T Stack Processor: at the P333T prompt, type
set interface inband <vlan> <ip-address> <netmask>
where,
<vlan> is the vlan number
<ip-address> is the IP address of the P333T Stack Processor
<netmask> is the subnet mask
e. Reset the P333T Stack Processor: type
reset <module-number>
where <module-number> is the module number of the G700 in the stack.
If necessary, re-start the Hyperterm session and log in.
f. Set up an IP route through the default gateway. At the P333T prompt, type
set ip route 0.0.0.0 <default-gateway-ip-address>
where,
<default-gateway-ip-address> is the IP address of the router or switch that
handles packets addressed to destinations outside of the subnet.
To Next Page
Loading...
