Job Aid: Replacing the G700 Media Gateway
44 Job Aids for Field Replacements (FRUs) for the Avaya S8300 Media Server with the G700 Media
a. Enable file system for the G700:
- Connect to the primary server and start a SAT session.
- At the SAT type enable filexfer and press Enter.
- Login: 3-6 alphanumeric characters
- Password: 7-11 characters with at least one number
- Reenter Password: type the same Password
- Secure: type n for FTP or y for SFTP.
- Board address: <nnn>v9, where <nnn> is the administered media gateway number.
b. Log in to a computer connected to the customer LAN. This computer will be used as an
"FTP client" to temporarily store the G700 VAL announcements.
c. Copy the existing announcement files from the G700 to the FTP client.
- At the command prompt on the FTP client, type
ftp <ip-address>
where <ip-address> is the IP address of the media gateway processor (MGP) on
the G700.
- At the user prompt, type the ftp-username you set up in Step a
.
- At the password prompt, type the ftp-password you set up in Step a
.
- At the ftp> prompt, type bin to change to binary mode.
- At the ftp> prompt, type dir to view the contents of the /annc directory.
- At the ftp> prompt, type
get <filename>.wav
where <filename> is the file name of an announcement file that you want to back
up.
(The get command copies the announcement file to the directory from which you
initiated the FTP session on the FTP client.)
- Repeat the get command for each announcement file you want to back up.
d. Type bye to close the FTP session.
enable filexfer Page 1 of 1
ENABLE FILE TRANSFER
Login:
Password:
Reenter Password:
Secure?
Board address:
To Next Page
Loading...
