Issue 4.1 June 2005 29
Chapter 2: Configuring the hardware in the rack
Once the control network equipment is installed and connected, you must configure the SNMP
Modules in each UPS (if Avaya supplied), the SNMP Subagent in the Avaya Ethernet switch (if
Avaya supplied), and the two media servers. The first two are to allow that equipment to send
alarms (traps) to the media servers.
Configure the SNMP agents first, then install Avaya Communication Manager on and configure
the first media server and verify its operation before you install Avaya Communication Manager
on and configure the second media server.
This section covers the following procedures:
● Configuring the SNMP modules in the UPS on page 30
● Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 34
● Installing Communication Manager software on page 37
● Configuring the media server on page 42
● Configuring second media server on page 50
To Next Page
Loading...
