Enabling control of IPSIs
Issue 4.1 June 2005 69
Enabling control of IPSIs
Note:
Note: Make sure the IPSIs have the same, current firmware.
If a duplicated IPSIs, make sure that IPSI duplication is enabled before enabling
IPSI control. See Enabling IPSI duplication (duplicated control network only)
on
page 56.
These steps enable the IPSI circuit packs and allow them to control the port networks.
1. Type change system-parameters ipserver-interface and press Enter.
2. Make sure the IPSI Control of Port Networks: field is set to enabled.
3. Press Enter to effect the changes.
Verifying license status
These steps verify the license status.
1. Under Security, click License File and verify that the license mode is now normal.
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix:
Primary Control Subnet Address: 172. 22. 0. 0
Secondary Control Subnet Address: . . .
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled
To Next Page
Loading...
