Avaya S8700 Series - Chapter 8: Testing the Media Server Installation; Testing the TN2312 BP IPSI Circuit Pack

Issue 4.1 June 2005 83
Chapter 8: Testing the media server installation
This chapter provides tests for the control network, including
● reviewing the status of the configuration.
● testing the duplication link to the media servers
● testing the IPSI circuit packs.
In addition, it provides information on the LED status indicators for the media servers, Avaya
Ethernet switch(es), uninterruptible power supplies (UPSs), and different circuit packs. See LED
indicators on page 85.
Note:
Note: Circuit pack positions are usually given by cabinet, and slot. They may also be
given by port. The term cabinet refers to five G650 Media Gateway TDM-cabled
together in a rack, making up one port network. A port network is defined as a
group of media gateways connected together with one TDM bus.
Perform these tasks to test the configuration:
!
CAUTION:
CAUTION: To prevent unnecessary trouble tickets, do not enable the alarms (Alarm
Origination feature) until all installation and administration procedures are
completed.
● Testing the TN2312BP IPSI circuit pack on page 83
● Testing the license file on page 84
● Testing the media server LEDs on page 86
Testing the TN2312BP IPSI circuit pack
Note:
Note: Do these steps using a SAT session
Note:
Note: For SAT commands you must be on the active media server.
These steps test the TN2312BP IPSI circuit pack.
1. Type test ipserver-interface UUC and press Enter to test all clock and packet
interface components within the IPSI circuit pack.