Programming the IPSI circuit packs
Issue 4.1 June 2005 63
For the IPSI circuit packs to get static IP addresses, you must administer them directly through
the Ethernet port connection on the IPSI faceplate (top port). See Figure 5: Connecting directly
to the IPSI.
Figure 5: Connecting directly to the IPSI
Note:
Note: Make sure you have the password before proceeding.
Clearing the ARP cache
Depending on your laptop computer’s operating system (generally Windows 2000), you may
need to clear the Address Resolution Protocol (ARP) cache before entering a new IP address. If
you enter an IP address and your computer cannot connect, then you may need to clear the
cache.
1. On your laptop computer click Start > Run to open the Run dialog box.
2. Type command and press Enter to open a MS-DOS Command Line window.
3. Type arp -d 192.11.13.6 and press Enter to clear the Address Resolution Protocol
(ARP) cache in the laptop. This command responds with one of the following:
● The command line prompt when the cache has been cleared.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
