Issue 4.1 June 2005 71
Chapter 6: Completing the installation
administration
This section covers the following tasks:
● Verifying translations on page 71
● Setting daylight savings time rules on page 72
● Setting locations (if necessary) on page 73
● Verifying date and time on page 74
● Resolving alarms on page 74
● Enabling and disabling Ethernet switch ports on page 75
● Backing up files to the compact flash media (S8710 only) on page 77
● Backing up files to the PCMCIA flashcard (S8700 only) on page 78
● Telneting to media server on page 79
● Enabling alarms on page 79
● Registering the system on page 80
Verifying translations
These steps verify translations.
1. Type list configuration all and press Enter to view all the administered circuit
packs in the system.
2. Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3. Check the administration status on the following items:
● list station
● list trunk-group
● list hunt-group
Note:
Note: Even though you set the date, time, and time zone through the Web interface on
the media server, you also must set the daylight savings time rules and locations
and verify the date and time through SAT commands.
To Next Page
Loading...
