© 2017 Avaya Inc. All rights reserved
Release Notes for Avaya Scopia® XT Series Known Issues | 39
interoperability issue when it
placed a call towards an XT5000
MCU
If XT is configured with
Unicode name the ECS rejects
the H.323 call
Use a plain ASCII name for XT
Tandberg MXP Series
interoperability issue when
placing SIP TLS calls.
Configure > Advanced > Protocols > SIP > TLS >
Enabled =No
Presentation, sent in WCS mode
from an XT, is sent black from
MCU7000 to other XT (8.3.x or
not in WCS mode)
You cannot dial a recent
incoming ISDN number from the
Recent Calls list.
(Incident #156601)
Dial the ISDN number manually.
Before making an ISDN voice-
only call, you need to first
change the service mode to
manual.
(Incident #156599)
To make an ISDN Voice-Only call, perform the
following procedure:
From the web interface, select Administrator
Settings > Calls > Preferences > ISDN and change the
Service Mode to Manual.
Insert a different Service Code for 64K calls.
Add the same Service Code to the Gateway Service
Prefixes List and specify the type as voice-only.
Dial the ISDN/PSTN number and select 64K as the
required Call Rate (Advanced call options).
Equinox/Scopia
Conference
Features
Advanced conference features
(meeting roster, Equinox
recording, meeting
management via UI, web
collaboration, chat via SC and
web) in a Equinox/Scopia
Meeting are available only if XT
is managed by the iView hosting
the meeting or the solution is
9.x and the call is sip
Check that your XT is able to access the meeting
roster (you should see Local – Your XT Name listed
in XT UI, Participants tab). If this entry is not
available, please check that your solution is 9.x and
invite XT as sip participant in the meeting (you can
invite XT by dialling xt@xtipaddress in your Equinox
client, or sip: xtipaddress in Scopia desktop/mobile
clients), or ask your Equinox Solution IT reference to
add XT as managed endpoint in the Equinox
Management server.
MCU6000 doesn't manage
correctly the XT video privacy
option ( auto or hide video)
when in a sip call
Configure > Advanced > System > Customization >
Set Privacy Options = Image
If you are using multiple
monitors and there is no
presentation, you cannot select
the PIP layout.
When connecting to a XT
embedded meeting not as first
terminal, the arrows in FECC
page are not displayed after
"Control Far" selecting.
The camera of the active speaker in the embedded
MCU can be moved anyway
XT cannot send or receive
presentation if there is only one
XT Desktop Client in the
conference and that Client does
not have a webcam.
Embedded MCU license cannot
be enabled on systems with CPU
version lower than 2.0
Software
Upgrade &
Downgrade
Downgrading to
unsigned versions
XT Series refuses the downgrade
to a not signed version (8.3.X or
lower) in regular mode or in
recovery mode.
To downgrade XT to a version 8.3.X or lower, you
have to manually disable the “Verify Signature”
option in the Download menu for normal mode. For
recovery mode it is not possible to downgrade to an
unsigned version. You need to use a signed version
for recovery mode and then disable the above
option and downgrade the XT to previous version.
If you are updating a system
with PIC firmware rev 33
(implemented in versions up to
v3.1.019), the system might
keep rebooting, and the Codec
Unit’s LED or logo blinks 3 or 5
Disconnect and reconnect the power jack
connector.
To Next Page
Loading...
