Avaya Scopia XT Executive 240 - Page 40

© 2017 Avaya Inc. All rights reserved
Release Notes for Avaya Scopia® XT Series Known Issues | 40
times as an error code.
QC#26658
SI#169789
If you change parameters with a
newer version, or load factory
defaults with a newer version,
some parameters could be not
properly managed by earlier
versions when downgrading.
For instance, new gatekeeper
configuration supporting DNS
name is not available in previous
version, so when downgrading
you have to configure
gatekeeper again.
The same for the TLS
configuration and similar
settings.
Reconfigure the parameter to the default value or
restore the previous version backup configuration
after downgrading, especially if you changed
parameters with the new version or loaded default
values/factory defaults with the new version and
then downgraded the system.
RVXT5000-804
Uploading a SW package into
the XT codec through USB key is
not possible
- whenever the SW Package is
not newer than the one already
running
- when trying to upgrade from
v8.3.0.x (or older) to a v8.3.2 or
higher; in this case it’s firstly
needed to upgrade to any
v8.3.2.x using a Windows PC
- when a password is set for the
software upgrade
- when the *.exe package copied
into the USB Key has been
renamed to a different name
than XT5000_Vx_y_z.exe or
XT7000_Vx_y_z.exe
- when the *.exe package is not
contained in the root directory
of the USB key.
Network
QC#18670
QC#19192
SI#8192-14380
Network negotiation issues
occur on both ports when using
specific network equipment, like
CISCO C2960.
Always configure Autosensing in both the XT and
the GLAN Port.
Alternatively, you can limit the auto negotiation
mode to 100/Full or lower.
QC#16278
In few/random cases the XT
does not get the IP Address in
permanent way from DHCP.
Set the Speed/Duplex Mode to 'Automatic - Up to
100/Full' or lower.
QC#18450
The system may not function
properly after modifying the
network settings.
Reboot the system to apply the update.
QC#18671
To execute commands when
using a telnet connection to port
60123, press 'Enter' twice after
each command.
QC#15025
If the system is set to check the
GLAN2 network as the preferred
network, it is possible to make
outgoing SIP UDP calls to a local
IPv6 link over the GLAN1
network.
Set GLAN1 as the Preferred Network (default)
QC#26262
The XT GUI displays the un-
correct network information
when detaching and attaching
the cable very quickly while
using an old Aethra DHCP
server.
Mac address conflict can be
displayed when connecting the
two GLAN ports to the same
subnet
This configuration is not supported by the endpoint.
Please connect each GLAN port to a different
subnet.
XT could not automatically
determine your country or time
zone correctly.
The Quick Setup wizard connects to some Internet
public geo-localization services to determine the
system location and time zone. The availability of
such services is not guarantee. When using a proxy