Figure 16: Rear panel of the device
2. Connect the other end of the power cable to the AC power.
3. Use a serial cable to connect a PC to the device's serial port. This connection is required for
local configuration and maintenance.
Important:
Do not connect a screen or a keyboard to the device directly. Define the device's basic
settings via the serial connection only.
4. Connect a network cable to the NIC1 Ethernet connector on the rear panel (see Figure
16: Rear panel of the device on page 20).
Use both Ethernet connectors for dual-NIC deployments. A dual-NIC deployment raises
security by using different subnets for media versus management. Use NIC1 Ethernet
connector for management and the NIC2 connector for media.
Configuring the IP Address for the Avaya Scopia
®
Application server
The Avaya Scopia
®
Application server comes preconfigured with an automatic IP (DHCP) address.
To configure a static IP, navigate to the Network and Sharing Center under Windows Control Panel.
For more information, refer to the relevant documentation from Windows.
Verifying the Server Installation
About this task
After you installed the device and performed its initial configuration, you need to verify that it is installed
and configured correctly.
Installation Guide for Avaya Scopia
®
Application Server Version 2 Setting up the Device | 20
To Next Page
Loading...
