Figure 9: Side view of rack with the outer rail attached
3. Repeat all steps to mount the outer rails to the other side of the rack.
4. Continue with Mounting the Device on to the Outer Rails on page 15.
Mounting the Device on to the Outer Rails
About this task
After you have attached the outer rails to the rack to form a support for the device, you can attach the
inner rail extensions to the device and mount the device on to the rack.
Caution:
To prevent injury and equipment damage, follow the lifting guidelines described in the Safety Guide
when lifting or moving the device.
Before you begin
•
Read the safety guidelines described in the Safety Guide.
•
Attach the outer rails to the rack, as described in Mounting the Outer Rails on to the Rack
on page
11.
•
Make sure you have the following items, which were shipped with the device and are used to
mount the rails to the rack (Figure 10: Preparing the parts required to mount the device onto the
rails on page 16):
–
Two inner rail extensions
–
Two flat-head short screws (Phillips cross recessed flat-head machine screws 6-32
UNCx3/16")
Installation Guide for Avaya Scopia
®
Application Server Version 2 Setting up the Device | 15
To Next Page
Loading...
