–
Two flat-head long screws (Phillips cross recessed flat-head machine screws M5x12mm)
–
Two brackets (finishing washers M5)
Figure 10: Preparing the parts required to mount the device onto the rails
Procedure
1. Attach the inner rail extension to the rear of the device:
a. Slide the rear inner rail extension towards the front of the device (see Figure
11: Attaching inner rail extensions to the device on page 16).
The hooks on the side of the device fasten the inner rail in place.
Figure 11: Attaching inner rail extensions to the device
b. Secure the rear inner rail extension through one of the two holes on the rail extension,
using one flat-headed short screw (Figure 12: Securing rail extensions to the device on
page 17).
Installation Guide for Avaya Scopia
®
Application Server Version 2 Setting up the Device | 16
To Next Page
Loading...
