Important:
To unfasten the rail pins from the rack, push the safety latch to release:
Figure 7: Removing the rack from the rails
c. Secure the rail by inserting a long screw and a washer through the rear rack post only
(Figure 8: Securing the rail to the rack on page 14). Insert the washer between the long
screw and the rail, as shown below.
The rail is secured to the front of the rack only after the device is mounted, as described
in Mounting the Device on to the Outer Rails on page 15.
Figure 8: Securing the rail to the rack
The outer rail is now attached to the rack, as shown in Figure 9: Side view of rack with
the outer rail attached on page 15.
Installation Guide for Avaya Scopia
®
Application Server Version 2 Setting up the Device | 14
To Next Page
Loading...
