Figure 1: VSP 4850GTS
1. VSP 4000 USB device with USB device cover
Caution:
To ensure proper operation, the USB FLASH drive must remain inserted in all models of VSP 4850
(factory built and converted from ERS 4850), with the cover installed for additional protection against
removal. The USB FLASH drive on the VSP 4850 switch is uniquely bound to the system it was first
used on and cannot be transferred to a different switch.
2. Switch LEDs
3. 10/100/1000 ports (LEDs above ports)
4. Combo port SFP slots. Supports Avaya 1G SFPs and 100Base low speed SFPs.
5. SFP+ slots. Supports Avaya’s 1G SFPs and 10G SFP+s.
6. Console port
Figure 2: VSP 4850GTS-PWR+
1. VSP 4000 USB device with USB device cover
Caution:
To ensure proper operation, the USB FLASH drive must remain inserted in all models of VSP 4850
(factory built and converted from ERS 4850), with the cover installed for additional protection against
removal. The USB FLASH drive on the VSP 4850 switch is uniquely bound to the system it was first
used on and cannot be transferred to a different switch.
2. Switch LEDs
Table continues…
Installation fundamentals
May 2016 Installing Avaya Virtual Services Platform 4850GTS Series 17
Comments on this document? infodev@avaya.com
To Next Page
Loading...
