45
You can also use the supplied Remote Control to quickly set up the Presenter Mode.
1. Adjust the camera view properly and then save to preset 1 as the initial position.
2. Press the Auto Tracking “On” button to enable the function.
3. Press the UPPER BODY button to track the presenter with a closer view (up to 60% of body), or
FULL BODY to track the entire presenter in the view.
4. Press Switch to switch between presenters. Initially the camera tracks the one who is in the
center of view. Every switch follows the sequence: left to right, then back to far left one in the
camera view (see picture below). To see which presenter is being tracked, press numeric key ”7”
for seven times to call/cancel engineering mode while tracking, you will see purple boxes shown
on all human-outline objects, and who under yellow box is being tracked.
To Next Page
Loading...
