Avery Dennison 6059 - Checking Software Version; Printing Test Labels

5-2 Operator's Handbook Classification: Avery Dennison – Public
Checking the Software Version
To check the printer’s software version: <- Where is this?
1. Turn on the printer.
2. From the printer’s Main Menu, use  or  until you see Configuration, then press Enter.
3. Use  or  until you see Version, then press Enter.
The printer’s version number is displayed. Press ESC to return to the previous menu.
4. Press ESC until you return to the Main Menu.
Printing a Test Label
To print a Test Label: <- Where is this?
1. From the printer’s Main Menu, use  or  until you see Diagnostics, then press Enter.
2. Use  or  until you see Printer, then press Enter.
3. Use  or  until you see Test Labels, then press Enter.
4. Select from the following test labels:
Select: The following labels print:
Diag Label
Prints a label with version numbers, voltage, printhead information
and blackmark sensor values.
Test Pattern
Prints a label to verify that the printhead strobes
are working. If your printed sample has fewer lines
or no lines, keep the sample and call Service.
Model: M6033
PE Firmware Rev: AB
PE Hardware Rev: AB
PE Voltage: 7.92 V
PE Current: 107 mA
PH Avg. Resistance: 347 ohms
Num Bad dots 0
PH Temperature (raw): 697
Blackmark sensor: 1.56 V
DRAFT