03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
19
Assembly
To assemble the device, follow the steps in
the reverse order. Make sure to do the
following:
Mount the stop disc (6) with the larger
chamfer pointing outwards.
Lightly grease the bearing surface of the
brake lever (5) before assembly (with
universal grease). Make sure that no
grease gets between the discs! Mount
the brake lever with the bulge side (fig.
right, arrow) facing outward.
Mount the brake disc (4) with the sharp
edge pointing outwards.
Screw the cap and nut onto the
threaded rod till they reach the depth
noted earlier.
After the assembly: set the braking
torque.
See section Setting the braking torque
on page 27.
5
4
6
To Next Page
Loading...
