2-2 User Manual
2. Press Enter. You see
PRINTER MENU
SUPPLY TYPE
3. Press or to move through the Printer Setup menu.
Setting the Supply Type
The printer has a black mark/die cut sensor, which it uses to properly
calibrate supplies. Black mark supply has sense marks (black marks) on
the back of them. Die cut supply does not have any black marks.
1. From the Printer Setup menu, press or until you see
SUPPLY TYPE
2. Press Enter. You see
PRINTER SUPPLY MENU
BLACK MARK BM
3. Press or to select the supply type you are using, then press
Enter. The current setting is displayed on the right. The default is
Black Mark.
4. Press or until you see
RETURN TO PRINTER MENU
5. Press Enter.
To Next Page
Loading...
