Setting up the printer 2-5
Sending the Configuration
When you change the printer’s configuration, you must send the new
settings to the printer or it uses the default settings of Black Mark, No
Peel, and No Ribbon.
1. From the Printer Setup menu, press or until you see
SEND CFG TO PRINTER
2. Press Enter. The new configuration settings appear.
For example:
PRINTER CONFIGURATION
BM NPL NRB SEND Y/N?
Where BM is Black Mark, NPL is No Peel, and NRB is No Ribbon.
3. Select Yes to send the new configuration to the printer.
Select No to return to the default settings.
4. Press Enter.
5. When you are done, select Return to Main Menu and press Enter.
To Next Page
Loading...
