Avery Dennison Monarch 9855 - Page 4

LOADING RIBBON ....................................................................................... 3-1
Loading Ribbon....................................................................................... 3-2
Using a High Energy Ribbon .................................................................... 3-4
High Energy Ribbon Limitations............................................................. 3-5
SETTING SUPPLY OPTIONS......................................................................... 4-1
Setting the Supply Type........................................................................... 4-3
Setting the Ribbon .................................................................................. 4-4
Setting the Speed ................................................................................... 4-5
Setting the Feed Mode ............................................................................ 4-6
Setting the Backfeed ............................................................................... 4-7
Changing the Position Settings................................................................. 4-8
Setting the Print Position...................................................................... 4-8
Setting the Supply Position................................................................. 4-10
Setting the Margin Position................................................................. 4-11
Setting the Cut Position...................................................................... 4-12
Setting the Dispense Position ............................................................. 4-12
Setting the Backfeed Distance ............................................................ 4-13
Using Batch Separators ......................................................................... 4-14
Using Skip Index................................................................................... 4-15
Setting the Knife Control........................................................................ 4-16
Setting the Error Action ......................................................................... 4-17
Setting the Print Contrast ...................................................................... 4-20
Enabling the Verifier ............................................................................. 4-22
ii Operator's Handbook