Setting the Ribbon
You have to tell the printer if your supplies require a ribbon. To change the
setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
1. Press » or ¼ until you see
SUPPLY
Ribbon ¼
2. Press Enter/Pause to set the ribbon option. The current setting is
displayed, for example:
RIBBON
» Yes ¼
3. Press » or ¼ to see the other options. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.
Note: If you set the Ribbon option to Yes, install a ribbon before printing.
If you want to use a high energy ribbon, select high energy for the
ribbon.
4-4 Operator's Handbook
To Next Page