XR Series Installation and Technical Instructions 9
2.1 Installing the XR 4500, XR 4500TL or XR 6500
Pre-installation (Receiving
Inspection)
It is always good practice to verify that the unit is complete and undamaged
upon receipt.
• Check over packaging for any signs of damage.
• Remove the XR from its protective packaging and check for damage.
• Verify that the shipment includes:
Correct XR remote display (complete and intact, with power cord).
Installation and Technical Manual.
• Displays ordered with the wireless option should include:
Radio module
External antenna
Internal antenna cable
Base station kit
Opening an Unmounted
Enclosure
1. When opening an XR unit (4500 / 4500TL / 6500) prior to mounting,
place the unit top-down on a smooth, flat, surface.
2. Make sure the unit is disconnected from power.
3. Remove the captive screws from the bottom of the enclosure.
4. Angle the electronics carriage so the tabs are at opposite corners of
the main enclosure opening.
5. Guide the electronics carriage out of the main enclosure, being
careful to avoid bending any LED leads. Each LED is mounted very
close to the PCB to prevent bending.
6. Place the electronics carriage bottom-down on the flat surface as
illustrated. See Figure 2.1
Installation
To Next Page
Loading...
Need help?
General
